1. The conductor adopts tinned copper wire, its structure meets the requirements in the following table, and its performance meets the requirements of jb947-76 rubber and plastic insulated wire and cable copper conductor core; 2. The performance of insulating rubber meets the standard of JB664-77 rubber for wire and cable; the insulation thickness meets the requirements in the following table, with allowable deviation of - 10%, and the thickness of * thin part is not less than 90% - 0.1mm of the nominal value;

3、护套橡皮性能符合JB664-77《电线电缆用橡皮》标准规定;1、导体采用镀锡铜丝,其结构符合以下表中的规定,JEM电机引接线性能符合JB947-76《橡皮和塑料绝缘电线电缆铜导电线芯》中的要求;2、绝缘橡皮性能符合JB664-77《电线电缆用橡皮》标准规定;绝缘厚度符合以下表中的规定,允许偏差-10%,其*薄处的厚度不小于标称值的90%-0.1mm;
3、护套橡皮性能符合JB664-77《电线电缆用橡皮》标准规定;护套厚度符合以下表中规定,允许偏差-20%,*薄处厚度不小于标称值的80%;
4、成品电线须经受OYYDDL0118-2003规定的交流50Hz耐电压试验;
5、成品电线导线线芯直流电阻在温度20℃时应符合表1、表2的规定;

6、电线应能经受浸漆试验,电缆经130±5℃、5小时恒温后,浸入温度为50±5℃的1032漆中30分钟
护套厚度符合以下表中规定,允许偏差-20%,*薄处厚度不小于标称值的80%;
5、成品电线导线线芯直流电阻在温度20℃时应符合表1、表2的规定;
;

6、电线应能经受浸漆试验,电缆经130±5℃、5小时恒温后,浸入温度为50±5℃的1032漆中30分钟
6.